Brother PR-600II, User Manual

Page: 191 / 237

APPENDIX ——————————————————————————————————————————————————————————
174
5
Insert the pad between the machine bed and
the ring of the cap frame driver.
1 Pad
2 Machine bed
3 Ring of the cap frame driver
6
Lightly press down the ring, and then use the
Allen screwdriver (large) to tighten the four
hexagonal screws on the inside of the ring.
Firmly tighten the screws.
1 Ring
7
Remove the pad inserted in step
5
.
■
Installing the needle plate spacer
Attach the needle plate spacer to the needle plate.
1 Needle plate spacer
■
Preparing the mounting jig
Lower the stopper, and then attach the mounting
jig to a stable surface, such as a desk.
1
Use a Phillips screwdriver to loosen the two
screws, and then lower the stopper in the
direction of the arrow.
1 Loosen the screw so that the stopper can be
hooked onto the screw and clamped with it.
2 Loosen until the stopper moves.
3 Stopper
●
Make sure that each hexagonal screw is
firmly tightened. If any screw remains
loosen, injuries may result.
CAUTION
1
Sapphire_chapt7.fm Page 174 Friday, November 18, 2005 12:10 PM