Brother MFC-J220, Service Manual

Page: 383 / 537

9-31 Confidential
9.4.14 Fine Adjustment of Scanning Start/End Position (Function code 54)
„
Function
This function allows you to adjust the scanning start/end position.
For models without an ADF, selecting "1.ADF" in steps (2) and (3) below produces nothing.
Select "2.FB" to adjust the start/end position of flat-bed scanning.
„
Operating Procedure
Models except DCPJ140W
(1) Press the 5 and 4 keys in this order in the initial stage of the maintenance mode. For models
without numerical keypad, enter 5 and 4 in this order using the , and OK keys.
The "SCAN START ADJ." appears on the LCD.
(2) Wait for the LCD to display the "1.ADF 2.FB."
(3) Press the 1 or 2 key. For models without numerical keypad, enter 1 or 2 using the , and
OK keys. The current scanning position correction value appears.
You can adjust the correction value to 11 levels from +5 to -5 (mm).
(4) To increase the correction value, press the key; to decrease it, press the key.
NOTE: In models with touch panel, if the and keys are not displayed on the software
keypad, it is necessary to switch the software keypads between the numerical and function
keypads by pressing the
Scan and Copy keys simultaneously.
If you press the Stop/Exit key, the machine returns to the initial stage of the maintenance
mode without making change of the correction value.
(5) Press the OK key ( Photo Capture key for models without OK key).
The "ACCEPTED" appears on the LCD. After one second, the LCD returns to the "1.ADF
2.FB" screen.
(6) Press the Stop/Exit key to return to the initial stage of the maintenance mode.
Note : The relationship between
the scanning start/end positions
and their correction values is
shown below.
5 and 4 keys
1 or 2 key
Stop/Exit key
Stop/Exit
key
OK
key
Stop/Exit
key
OK
key (
Photo Capture
key)
( Photo Capture key)
1 second later
Right arrow key Left arrow key