HE-800C
6. USING THE SEWING MACHINE (SEWING OPERATION)
49
3
Place the material under the work clamp, and then depress the treadle (5) to the 1st step (B).
The work clamp will drop.
4
Depress the treadle (5) to the 2nd step (C).
Sewing will then start.
*
When sewing is complete, the work clamp will
rise.
5
To repeat the sewing operation, repeat steps 3 and 4 above.
6-2. Test feeding mode
This mode lets you check needle zigzag, work clamp and length feed plate movement in the sewing pattern which has been
programmed without actually sewing the program.
(The needle will not move up and down and the cutter will not operate either.)
1
Switch the mode to test feeding mode.
The sewing pattern (1), the program number (2) and the number of
stitches (3) will appear in the display.
2
Select the program number (2) for test feeding.
The program number (2) changes in the order shown in the
illustration each time the
key is pressed.
(The
key changes the order in the opposite direction.)
4818M
4819M
4821M
4820M
4210B
4787M
Independent program
(Refer to P. 33)
Cycle program
(Refer to P. 53)
