SSS
™
1127 |
15
Visit Static Control
®
on the web @ www.scc-inc.com
SSS
™
1127
STEP 5.7
STEP 5.6
STEP 5.4
STEP 5.8
Remove the spent drum by rotating and pulling upwards
(Figure 5.7).
Clean the drum unit, transfer roller and corona assembly with
dry, filtered, ionized, compressed air (Figure 5.8).
Remove the drum axle from the drum unit (Figure 5.6).
Remove the white locking retainer and black stabilizer ring
from the drum axle and set them aside.
Use a small, slotted screwdriver to press the tab on the locking
bearing (Figure 5.4A) and remove the bearing using needle
nose pliers (Figure 5.4B).
FIGURE 5.7
FIGURE 5.6
FIGURE 5.4B
FIGURE 5.4A
FIGURE 5.8
DISASSEMBLING THE DRUM UNIT
Note:
Be careful not to lose any of the smaller parts
while cleaning the drum unit.
Small
Slotted
Screwdriver
Tab on
Locking
Bearing
Locking
Bearing
Needle
Nose
Pliers
Locking
Retainer
Stabilizer
Ring
Drum Axle
CONTACT SIDE
CONTACT SIDE
DRIVE SIDE
Drum Unit
Compressed
Air
STEP 5.5
Push the drum axle on the contact side of the drum unit toward
the drive side until the small white locking retainer and black
stabilizer ring are visible (Figure 5.5).
FIGURE 5.5
Locking
Retainer
CONTACT SIDE
DRIVE SIDE