Brother BES-1261BC, Instruction Manual

Page: 143 / 164

Chapter 8 Standard Adjustment
BES-961BC
•
BES-1261BC
141
1. Dismount the pulley cover and turn the pulley B
q
until the pulley scale indicates 180˚ and the
needle bar is set at the lowest position. (The pulley B "2" mark and the stop mark "2" are aligned.)
2. Insert the positioning bar
w
into the hole of the pulley
q
and fix the drive shaft.
Note) Turn the pulley B securely in the clockwise direction to eliminate a backlash.
3. Loosen the needle bar clamp set screw
e
and the bolt
u
of the top dead center stopper
t
when
the needle tip is positioned 10.8 mm above the center of the rotary hook shaft. Adjust the position of
the needle bar thread guide so that the set screw
r
on it is turned to the right by 25 ~ 30˚. Tighten
the needle bar clamp set screw
e
securely.
Note) When tightening the needle bar clamp set screw
e
, the hole in the needle bar guide should face the front.
4. After adjustment is finished, remove the positioning bar
w
.
5. Set the needle bar at the highest position (where the pulley B indication mark "1" and the cover
indication mark "1" are aligned). Lightly press the top dead center stopper
t
toward the cushion
rubber
y
, and tighten the top dead center stopper bolt
u
while pressing down the needle bar clamp
so that it faces the front.
Note) • Make sure that the top dead center stopper does not hit the needle bar guide rail
i
at this time.
• When tightening the upper dead point stopper bolt
u
, insert the longer side of the attached wrench into the
bolt and tighten it by using the shorter side.
Excessive tightening may make the needle bar movement sluggish.