2. PREPARATION
2-4.Installing the auxiliary legs
―
5
―
BAS-705
1. Remove the two auxiliary legs
w
which are secured
to leg frame
q
.
2. Re-install the two removed legs
w
as shown in the
illustration at left, and secure them with the bolts
e
,
spring washers
r
and flat washers
t
which were
removed before.
3. Loosen the nuts
u
(in two places) and turn the level
adjusters
i
to adjust the height of the casters
y
above the floor.
NOTE: After adjusting, securely tighten the nut
u
.
q
w
i
t
r
y
e
u
2-5. Checking the loop cutting
NOTE: At the time of shipment from the factory, the V-
cutting cylinder is in the lock position (flat-end
cutting).
■
Changing to V-shaped cutting
1. Remove the
q
, set the knife stopper
w
to the posi-
tion shown in the illustration at left, and then re-tighten
the bolt
q
.
2. Check that DIP switch No.1-2 on the panel is set to
“ON”.
No 1
w
q
