6-2. Adjustments required when the belt loop width is changed
6-2-1. Adjusting channel
1. Loosen the two bolts
q
up to 7 mm, and remove the
channel assembly from the unit.
NOTE:
Fine adjustment of channel B (left side)
w
should be carried out while the channel as
sembly is attached.
2. Loosen the four screws
e
and align the channel to
the width of the belt loop.
(Example)
How to align if the belt loop width is 14 mm
(a) Align the perpendicular surface of channel F
(right side)
r
with a line 7 mm from the cente
line.
(b) Set the position of channel B (left side)
w
so
that the belt loop joints pass through smoothly.
NOTE:
If the center of the V cut is misaligned, move
channel F (right side)
r
horizontally.
3. Position the coupler of the channel to the coupler of
the unit base. Secure them using the bolt
q
.
6. STANDARD ADJUSTMENT (MECHANISMS)
1. With loop presser B
q
and loop presser F
w
both in
the raised position, loosen the clamp lever
e
.
2. Turn the bolt
r
so that the left edge of channel F
t
is aligned with the edges of loop presser B
q
and
loop presser F
w
.
3. Tighten the clamp lever
e
.
NOTE: If the belt loops run along the right edge of
channel B, align the edges of loop presser
B
q
and loop presser F
w
the end of the
belt loops.
6-2-2. Adjusting the width adjustment plate
―
52
―
BAS-705
t
q
w
e
w
r
q
belt loop
coupler
w
r
center line
center line
9mm from center line
10mm from center line
8mm from center line
7mm from center line
6mm from center line
5mm from center line
r
e
loop width
adjustment plate