NOV12GB Issue 2
22
Warning Notes
Over-Firing
It is extremely important that you do NOT leave all of the air controls in the fully open
position for extended periods or run the appliance with the door open. Leaving the air
controls fully open (or running with the doors open) will lead to “over-firing”. Over-firing is
caused when too much heat is generated within the fire chamber, this will lead to warping,
buckling and general damage to the stove and its internal components. Over-firing can
also be caused by an excessive flue draft.
PLEASE
NOTE
ANY
DAMAGE
TO
THE
APPLIANCE
CAUSED
THROUGH
OVER-
FIRING
WILL
NOT
BE
COVERED
BY
THE
WARRANTY.
We highly recommenced the use of a flue pipe thermometer so that you can monitor how
much heat you are sending up the chimney, this will both enable efficient operation of your
stove and also give a good indiction if you are over-firing the appliance.
Fumes
Properly installed, operated and maintained, this appliance will not emit fumes into the
dwelling. Occasional fumes may occur whilst de-ashing and re-fuelling. However,
persistent fume emission is potentially dangerous and must not be tolerated. If fume
emission does persist, the following immediate actions should be taken:-
a)
Open doors and windows to ventilate the room
b)
Let the fire go out or eject and safely dispose of fuel from the appliance
c)
Check for flue or chimney blockage and clean if required
d)
Do not attempt to relight the fire until the cause of the fume emission has
been identified and corrected. If necessary seek expert advice