2) Turn off water supply valve and
flush toilet
a. Turn off water supply at the wall to
stop flow of water .
b. Flush toilet and hold down handle
to completely empty toilet tank .
c. Disconnect water supply hose from
water shut off valve . You may have
to use a 3/8’’ compatible wrench or a
similar tool if the connection is tight
(not supplied) .
3) Connect T-valve to supply line
Note: Do not connect FreshSpa to
hot water line. Only connect to a cold
water pipe.
a. Install the T-valve and the small
rubber washer onto the water shut
off valve coming out of the wall .
b. Connect the water supply line to
the open end of the T-valve using the
second small rubber washer (if needed) .
4) Connect the Bidet Hose to the T-valve
a. Connect one end of the bidet hose to
the remaining open side of the T-valve .
5) Install Bidet Attachment on Toilet
a. Place large rubber washers over the
open bolt holes in the toilet fixture .
b. Place bidet attachment over
washers so the nozzle is as close to
the back of the toilet bowl as it will go .
This will vary by toilet .
c. Make sure the adjustable brackets
line up with the holes in the toilet
fixture . You may need to move the
adjustable brackets accordingly to
line up properly .
d. Replace the toilet seat on top of
bidet attachment and secure using
original toilet seat hardware . Make
sure to tighten so that the bidet
attachment and seat do not move .
Step 2a
Step 4a
Step 5
Step 2c
Step 3a & 3b
Installation
Installation
6
7
Summary of Contents for FS-10
Page 1: ...Owner s Manual FS 10 FreshSpa ...
Page 9: ......