brondell FS-10, Owner'S Manual

Page: 6 / 9

6) Connect Bidet Hose to Bidet Attachment
a. Connect open end of bidet hose to the
brass connection on the bottom side of
the bidet attachment .
7) Turn on Water Supply & Check for Leaks
a. Open the main water supply valve slowly and check for
leaks .
b. Wait 5-10 minutes, check again and if there are no leaks
continue .
Note: if there is any leaking, check all rubber washers and make
sure all water connections are tight and secure. If necessary,
you can use plumbers tape for any leaking connections.
Operation
Using the FreshSpa
To clean the bidet nozzle, turn the control dial towards the “Nozzle
Cleaning” position and water should wash over the nozzle .
For the general bidet wash function, turn the dial towards the
“Wash” position .
•
The further the dial is turned, the higher the water pressure will be .
•
To lower the water pressure, turn the nozzle back towards the center .
For a front wash function, women may need to tilt & bend forward
slightly in order for the spray to hit the appropriate areas .
Installation
Step 6a
1
2
3
Nozzle positioning
There are 3 different nozzle
positions that you can easily
adjust by gently pulling the
end of the nozzle forward
or backwards . Once desired
position is set, the nozzle will
remain in that position until
manually moved .
8 9