14
7. Setting additional functions
The "
aux
" key (22) is used to select additional functions. Repeated actuation of the key
toggles through the following display modes:
-
Select proportionality level of the modelling light
LED "prop" blinks (17)
-
Fast charge on / off (on/--)
LED "fast" blinks (18)
-
Buzzer on / off (on/--)
LED "buz" blinks (19)
-
Dim charge on / off (on/--)
LED "dim" blinks (20)
-
Define sequences (serial flashes)
LED "seq" blinks (21)
-
Studio address / set unit address
LED "unit" blinks (23)
-
Return to standard display
no LED blinks
After the setting has been performed, the standard display can be re-activated by
pressing the
"
aux
" key (22) or automatically after a waiting time of 4 seconds.
To set the additional functions select the respective LED (example: function "buz"). The
digital display of channel 1 (8) will then show the actual value which can be changed
with the "up/down" key (10). If a setting is entered which deviates from the basic setting
value, the respective LED will remain lit as a reminder after the display returns to
standard (exception: function "prop"). If the unit is switched off and on again, it will be in
the "standard display" mode. Previously set additional functions are retained.
7.1
Set proportionality level of the modelling light (prop)
The proportionality level of the modelling light can be selected by briefly pressing on the
"up/down" key (10) of channel 1. With repeated actuation of the key the following modes
can be set, each shown respectively on the digital display (8): LO, P, P1, P2, P3, P4,
P5, HI.
7.2
Fast charge (fast) on / off (on / --)
The mode "fast charge" can be selected by briefly pressing on the "up/down" key (10) of
channel 1 (on / --). To avoid overloading the mains supply, the "dim" function remains
on permanently during fast charge (see chapter 7.4) and cannot be deactivated.
The LED "DIM" lights up as soon as the modelling light is switched on ("mod" key)
Attention:
The mode fast charge is only suitable for certain lamp units (see chapter 12)
because of the large charge power.
7.3
Buzzer (buz) on / off (on / --)
The ready buzzer sounds when the power capacitors are 100 % charged up. The ready
buzzer is switched on or off (on/--) by briefly pressing the "up/down" key (10) of channel
1. The warning signal will remain audible even if the ready buzzer is switched off.
Summary of Contents for Verso A2 plus
Page 5: ...5 also valid for Verso A4 ...
