Bromic Heating PLATINUM 300 SMART-HEAT, Installation, Instruction And Service Manual, Page: 17 / 26

17
bromic.com/heat
IMPORTANT
Do not apply any additional surface coating to the heater under any
circumstances. Use of additional coating other than those applied
during manufacture could result in hazardous reactions such as
toxic fumes or fires. Additional coatings will void the warranty.
Replacement parts can be purchased to restore
the heater to its original appearance from Platinum
Heating Pty Ltd. (Refer to parts list in manual). !
Model A B
3 - Burner 1100mm 2500 - 3500mm
5 -Burner 1100mm 2500 - 3500mm
Model A
3 - Burner 6000 - 7000mm
5 -Burner 8000 - 9000mm
OPERATION DATA - HONEYWELL CONTROL BOX
The following operation sequence is valid only
where the components are installed according to the
manufactures assembly and installation instructions.
Please do not modify the wiring configuration, gas
train or any other part of the heater assembly.
Application
The Honeywell electronic gas burner control system
is suitable for atmospheric gas burners for non-
permanent operation. Although the Honeywell unit is
available non volatile lockout, its configuration in the
Platinum Smart-Heat series heaters limits it to volatile
lockout, i.e. the restart from this condition is possible
by the interruption and subsequent restoration of the
mains power supply.
Features:
• Compliance with AGA standard for automatic gas
burner flame monitoring and control systems
• Compliance with EN 298 (European standard for
automatic gas burner flame monitoring and control
systems)
• Compliance with AGA (Australian standard for
automatic gas burner flame monitoring and control
systems)
TECHNICAL DATA
Supply voltage 230V-50/60Hz
Operating temperature -20°C +60°C
Ambient humidity 90%max at 40°C
Protection degree IPX4
Timings:
Self Check time 1.5 s
Safety time (TS) 25 s
Drop out time on running flame
failure
1 s
Power consumption, at start up 10W
Power Consumption, Running 4W
Ignition
Ignition Voltage 15kV with 40pF
load
Spark repetition rate 33 Hz
Max. Cable length 1M
Recommended spark gap 0.14”
Consumption 2,5 W
OPTIMUM MOUNTING DISTANCE
A
B
B
A