Broderson IC-80-3L 4X2, Installation And Operating Manual

Page: 29 / 75

2-9
Normal engine speed-control uses the foot accelerator pedal. On gas engines, only a 3-
position switch on the right dash panel provides pre-set engine speeds. Parking brake must
be set to activate system. Press the high idle control switch temporarily to the right; the
engine will lock into the preset levels. The center position of the switch enables the engine
to dwell at 1800 RPM. The left switch position will lower the engine speed to 1200 RPM.
To restore the foot accelerator, either temporarily release the parking brake fully, or turn the
engine off. The following is an example for gas:
On diesel engines, your pre-set engine speeds will appear on the instrument panel:
Three-mode steering is standard. Rear steer, 4-wheel round steer, and crab steer can be
selected with a switch on the dashboard. The steering wheel is directly mounted to the
steering control unit of the all-hydraulic power steering system. The steering system will
provide limited steering even if the engine should stop running.
The Rated Capacity Limiter display and input panel are mounted on the dashboard.
Instructions are in the RCL Operation Manual and additional information is in the Operating
the Crane section, the Crane Capacity section, and Maintenance section of this manual.
Pre-set engine
speed switch
This display also
includes:
•
WIF Sensor
•
Oil Pressure
Indicator
•
Engine Load %
•
Engine Coolant
Temperature
•
Parking Brake ON
•
In NEUTRAL
Courtesy of CraneMarket.com