Broderson IC-35-2G, Operation And Maintenance Manual

Page: 10 / 71

1-6
Engine:
Standard Gasoline:
Kubota 1.6 L, EFI Dual Fuel, EPA Tier 4 Final Certified:
Kubota WG1605-GL-E3 gasoline engine complete with multi-port electronic
fuel injection, dual fuel, and engine management system. Water-cooled, 4-
cylinder, 94 CID (1.6 L), 3.11-inch (79 mm) bore, 3.09-inch (78.4 mm)
stroke, 43.7 HP (32.6 kW) at governed speed of 2600 rpm. Maximum
torque, 88.7 ft-lbs (120.2 Nm) at 2400 rpm. 70-amp alternator, 13.5-gallon
(51 L) gas tank, and 33 - lb (15 kg) LPG tank.
Optional Engines and Accessories:
Kubota 1.8 L, EPA Tier 4 Final Certified:
Kubota D1803-CR-TIE4B diesel engine. Water-cooled, 3-cylinder,
turbocharged and inter-cooled, 111 CID (1.8 L), 3.43-inch (87 mm) bore,
4.04-inch (102 mm) stroke. 49.6 HP (37.0 kW) at governed speed of 2700
rpm. Maximum torque 111.0 ft-lbs (150.5 N-m) at 1600 rpm. 12V, 60-amp
alternator.
Hydrostatic Transmission Pump:
Standard:
Sauer-Danfoss piston type, 2.8 CID (45 mL) per revolution, direct driven
from engine crankshaft. Maximum flow 34 gpm (129 L/min) maximum
pressure 4,000 PSI (275 bar). Electrohydraulic servo and electronic,
automotive type controller.
Axles:
Standard:
Front Axle:
Channel shaped structure houses torque hubs, brakes and hydraulic drive
motors. Front axle oscillates a total of 1.5 inches (38 mm) to minimize wheel
spin on uneven surfaces.
Rear Axle:
Fixed rigid to frame. Box beam crossmember and thrust bearing supported
wheel hubs.
Steering:
Standard:
Full-hydraulic steering unit controls 2.5-inch (63 mm) steering cylinder attached
to rear axle. Limited steering if engine dies.