Broderson IC-20-1J, Operation And Maintenance Manual

Page: 10 / 63

1-6
ENGINE:
Standard:
GM 2.4L, Woodward EFI Dual Fuel, EPA Tier II Certified:
Industrial gasoline engine complete with multi-port electronic fuel injection, dual
fuel, and engine management system. Water-cooled, 4-cylinder, 147 CID (2.4
L), 3.44-inch (87.4 mm) bore, 3.94-inch (100 mm) stroke, 65 HP (48 kW) at
governed speed of 2500 rpm. Maximum torque, 137 foot pounds (185 Nm) at
2300 rpm. 70-amp alternator, 13.5-gallon (51 L) gas tank, and 33 lb (15 kg)
LPG tank. Includes high temperature, low oil pressure shutdown, engine
management system, and a catalytic converter muffler.
Optional Engines and Accessories:
Kubota 2.4L, EPA Interim Tier 4 Certified:
Kubota V2403-M-E3B diesel engine. Water-cooled, 4-cylinder, naturally
aspirated, 148 CID (2.4 L), 3.43-inch (87 mm) bore, 4.03-inch (102 mm) stroke.
48.9 HP (36.5 kW) at governed speed of 2700 rpm. Maximum torque 118 ft-lbs
(160 Nm) of torque at 1800 rpm. 12V, 40-amp alternator.
Net weight: 80 pounds (36 kg)
Spark Arrestor Muffler:
Spark arrestor muffler used in addition to standard muffler.
Net Weight: 10 pounds (5 kg)
Engine Shutdown Kit:
Consists of Murphy switches that shut engine down if water temperature is
excessive or oil pressure is too low. For diesel engine only.
Hydrostatic Transmission Pump:
Standard:
Sauer-Danfoss piston type, 2.8 CID (45 mL) per revolution, direct driven from engine
crankshaft. Maximum flow 30 gpm (114 L/min), maximum pressure 3,000 psi (207
bar).
Axle:
Standard:
Front
Axle:
Channel shaped structure houses torque hubs, brakes and hydraulic drive
motors. Front axle oscillates a total of 1.5 inches (38 mm) to minimize wheel spin
on uneven surfaces.
Rear
Axle:
Fixed rigidly to frame. Box beam crossmember and thrust bearing supported
wheel hubs.
Steering:
Standard:
Full hydraulic unit controls 2.5 inch (63.5 mm) steering cylinder attached to rear axle.
Limited steering if engine dies.
Courtesy of Crane.Market