Brocade Communications Systems VDX 8770-8, Hardware Reference Manual, Page: 36 / 40

18 Brocade VDX 8770-8 Hardware Reference Manual
53-1002564-01
Port numbering
2
Port numbering
The Brocade VDX 8770-8 uses the following port numbering method ( Appendix D, “Port Numbering
Template” ):
•
12x40G line card module — Ports are numbered from 1 through 12 from from top to bottom
when installed in the chassis.
•
48x1G and 48x10G line card modules — Ports are numbered from 1 through 48, from top to
bottom, with the odd-numbered ports on the right row and the even-numbered ports on the left
row when installed in the chassis.
Providing power to the Brocade VDX 8770-8
Complete the following steps to provide power to the chassis.
DANGER
Use the supplied power cords. Ensure the facility power receptacle is the correct type, supplies
the required voltage, and is properly grounded. (D004)
1. Connect the AC or DC power cords to the power supplies. Each power supply has one power
cord.
2. For AC power, connect each power cord to a power source with nominal voltage of 200 to 240
VAC, 47 to 63 Hz. For DC power connect each power supply to a power source with nominal
voltage of -48 VDC.
3. The Brocade VDX 8770-8 performs a power-on self-test (POST) each time it is powered on.
POST may take several minutes and is complete when the indicator light activity displays the
operational state.
ATTENTION
Do not connect the switch to the network until the IP addresses are configured.
For information about LED patterns, see Chapter 4, “Monitoring System Components” .