Mounting the access point
2
Brocade Mobility 7131 Series Access Point Installation Guide
9
53-1001935-02
For detailed specifications on the antennas available to the Mobility 7131 Series
Access Points, refer to the
Brocade Mobility Series Access Point Product Reference
Guide
or the
Enterprise Wireless LAN Antenna Specification Guide
. Both guides are
available at
http://www.brocade.com/support/
.
Mounting the access point
Both the Brocade Mobility 7131 Access Point and Brocade Mobility 7131N Access
Point can attach to a wall, mount under a suspended T-Bar or above a ceiling
(plenum or attic) following the same installation instructions. Choose one of the
following mounting options based on the physical environment of the coverage
area. Do not mount the access point in a location that has not been approved in a
site survey.
Wall mounting
Wall mounting requires hanging the access point along its width (or length) using
the pair of slots on the bottom of the unit and the access point mounting template
(on the next page) for the screws.
CAUTION
An access point should be wall mounted to concrete or
plaster-wall-board (dry wall) only. Do not wall mount the access point to
combustible surfaces.
Part number
Antenna type
Nominal net gain (dBi)
ML-5299-WPNA1-01R
Panel Antenna
13.0
ML-5299-HPA1-01R
Wide-Band Omni-Directional
Antenna
5.0
ML-2452-APA2-01
Dual-Band
4.0
ML-2452-PTA2M3X3-2
Facade with 6 Element
Antenna Module
2.0
ML-2452-PTA3M3-036
3 Port MIMO Antenna
3.0
