178
Brocade MLX Series and Brocade NetIron XMR Installation Guide
53-1004195-02
Installing a NetIron XMR 32000 router
FIGURE 128
Routing lower-right quadrant cables
2.
Route cables from slots #30 and #29 down through comb A. Refer to
Figure 128
.
3.
Route cables from slots #28 and #27 down through comb B.
4.
Route cables from slots #26 and #25 down through comb C.
Accessing modules for service
With the cables bundled correctly, it is easier to access the modules for service. Gently move the cable bundles to the side to access a
module. Use the appropriate Phillips or flat-blade screwdriver with an extended shaft to disconnect the cables from the module and
remove the module. There is no need to undo the cable cinches or cable ties. Refer to
Figure
.
NOTE
This procedure is easier with two people. One person can hold the cable bundles aside while the other person loosens the
connectors and removes the module.
Be careful not to overtighten or cross-thread cable connector screws.
1
Lower right quadrant
3
Comb B (slots #27 and #28 cables)
2
Comb A (slots #29 and #30 cables)
4
Comb C (slots #25 and #26 cables)
2
3
4
1
