Brocade MLX Series and Brocade NetIron XMR Installation Guide
149
53-1004195-02
Installing a NetIron XMR 8000 router
DRAFT: BROCADE CONFIDENTIAL
FIGURE 105
Installing a power supply in a NetIron XMR 8000 router
4.
Push the power supply toward the back of the router until the power supply connector engages the backplane connector, and the
latch pin clicks into place.
5.
Install a power supply slot blank into all empty slots.
For information about connecting power to the router, refer to
“Connecting AC power”
on page 149, or
“Connecting DC power”
on
page 150.
Connecting AC power
AC power is supplied through an AC power cord that is installed at the back panel of the router.
NOTE
For the NEBS-compliant installation, AC power connections must use a surge protection device (SPD) to protect AC power
supplies from damage due to excessive power line surges.
Follow these steps to connect AC power source.
1.
Locate the power receptacle on the back panel of the router.
2.
Lift the cord retainer and connect an AC power cord to the power supply.
3.
Snap the cord retainer over the power plug to hold it in place.
FIGURE 106
Connecting a power cord to the power receptacle
