MODELS QP142SS • QP142WW • QP142BL
Page 5
12
DUCTED INSTALLATION ONLY:
Remove 3¼” x 10 vertical, 3¼” x 10” horizontal, or 7-inch
round
knockout plate(s)
as appropriate for your ducting
method.
13
DUCTED INSTALLATION ONLY:
Attach
3¼” x 10” Damper/Duct Connector
(if using 3¼”
x 10” duct) or
7” Round Duct Plate
(if using 7-inch round
duct) over the knockout opening.
3¼” X 10”
HORIZONTAL
KNOCKOUT
PLATE
3¼” X 10”
VERTICAL
KNOCKOUT
PLATE
7” ROUND
KNOCKOUT
PLATE (also
remove 3¼” x 10”
vertical plate)
7” ROUND
DUCT
PLATE
Notes:
To accomodate off-center ductwork, the 3¼” x 10”
damper/duct connector can be installed up to ½” on either
side of the hood center and the 7” round duct plate can
be installed up to ½” on either side of the hood center.
Install the 3¼” x 10” Damper/Duct Connector with the
Damper Flap Pivot
nearest the
Top/Back Edge of
Hood
.
INSTALL THE HOOD
15
Run
House Power Cable
between service panel and hood
location. Attach power cable to hood using appropriate clamp.
16
Hang hood from (4) mounting screws driven part-way into
cabinet locations (shown in illustrations under “PREPARE
HOOD LOCATION”). Mounting screws are included in parts
bag. Slide hood back towards wall until mounting screw
heads are engaged in narrow end of keyhole slots in top of
hood. Tighten screws securely. Add 5th mounting screw in
center hole in hood and tighten securely.
17
DUCTED INSTALLATION ONLY:
Connect ductwork to hood and use duct tape to make joints
secure and air-tight.
Make sure the damper / duct connector
enters the ductwork and that the damper opens and closes
freely.
HOUSE
POWER CABLE
WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
WIRING BOX
COVER
14
Remove
Electrical Wiring Box Cover
from inside
of hood and appropriate
Electrical Power Cable
Knockout
from top or back of hood.
ELECTRICAL
POWER
CABLE
KNOCKOUT
TOP/BACK
EDGE OF
HOOD
3¼” X 10”
DAMPER /
DUCT
CONNECTOR
DAMPER
FLAP
PIVOT
