-
8
-
12. INSTALL THE BLOWER
(INTERIOR BLOWER ONLY)
Assemble barrel nut (packed with blower) approximately halfway onto threaded
stud on top inside of hood.
Lift blower to top inside of hood. Slide blower back to engage blower tab with slot
in hood top and slot in blower with barrel nut.
HD0061
11. INSTALL THE HOOD
Rest the top back cavity of the hood on the wood mounting strip.
Attach transition to 10” round duct. Secure the hood to wood mounting strip with
(5) screws provided at locations shown. Drill (2) 3/16’’ size holes into the drywall
for wall anchors through the existing holes in the inside hood back in the
locations shown. Then, install the two wall anchors with the remaining #
8
x 3/4”
screws and the (2) washers provided.
CAUTION
Hold the hood until it is completely secured to the wood
mounting strip.
HD0184
T
OP OF HOOD
(
INSIDE VIEW
)
M
OUNTING SCREWS LOCATION
S
LOT IN TOP
OF HOOD
B
ARREL NUT ON
THREADED STUD
D
ISCHARGE
OPENING
D
ISCHARGE
OPENING
W
ALL ANCHORS LOCATION
B
ACK OF HOOD
(
INSIDE VIEW
)
Use a long, flat-bladed screwdriver to tighten the barrel nut securely. Plug motor
into receptacle, on exterior side of wire box.
HD0054
B
LOWER MOTOR
F
LAT
-
BLADED
SCREWDRIVER
B
ARREL NUT
9. INSTALL THE TRANSITION
Attach the provided transition to top of hood. Use metal duct tape to make all
joints secure and air tight.
HD0057
CAUTION
If this decorative flue is installed in a salt water area (example: coast), rinse all surfaces once a week with
clear water (even if the hood is not used), and wipe dry completely.
10. INSTALL THE DECORATIVE FLUE (OPTIONAL)
O
PTIONAL
D
ECORATIVE
F
LUE
AEWPD S
ERIES
Refer to the instructions included with the optional decorative flue.
