53-1005235-09 Installation Guide
Brocade
®
G630 Switch Hardware Installation Guide
LED Color
Status of Hardware
Recommended Action
Flashing amber and green
Attention is required. A number of variables
can cause this status, including a single
power supply failure, a fan failure, or
one or more environmental ranges being
exceeded.
Check the management interface and the
error log for details on the cause of the
status.
Contact your solution provider.
Management Port LEDs
Use the following table to interpret the management port LEDs.
Table 15: Management Port LED Patterns during Normal Operation
LED Function/State
Status of Hardware
Link/Speed—Green LED is on
1000Mb/s link
Link/Speed—Amber LED is on
10/100Mb/s link
Activity—Green LED is blinking
Presence of activity
FC Port Status LEDs
Use the following table to interpret the FC port status LEDs.
Table 16: FC Port Status LED Patterns during Normal Operation
LED Color
Status of Hardware
Recommended Action
No light
Indicates one of the following:
•
No signal or light carrier (media or
cable) detected.
•
The device may be currently initializing.
•
The connected device is configured in
an offline state.
•
Verify that the power LED is on, and
check the SFP+ and cable.
•
Verify that the device is not currently
being initialized.
•
Verify the status of the connected
device.
Steady green
The port is online (connected to an external
device) but has no traffic.
No action is required.
Slow-flashing green (on for 1 second; then
off for 1 second)
The port is online but is segmented
because of a loopback cable or
incompatible device connection.
Verify that the correct device is attached to
the switch.
Fast-flashing green (on for 1/4 second; then
off for 1/4 second)
The port is online, and an internal loopback
diagnostic test is running.
No action is required.
Flickering green
The port is online, and frames are flowing
through the port.
No action is required.
Steady amber
The port is receiving light or signal carrier,
but it is not online yet.
No action is required.
Slow-flashing amber (on for 2 seconds;
then off for 2 seconds)
The port is disabled because of diagnostics
or the
portDisable
command.
Reset the port.
The
portCfgPersistentDisable
command is persistent across reboots.
Fast-flashing amber (on for 1/2 second;
then off for 1/2 second)
The SFP+ or port is faulty.
Reset the port.
Replace the SFP+. Must be a Brocade-
branded SFP+.
53-1005235-09
65
Summary of Contents for Brocade G630-1
Page 99: ......
