il
@b
d
l
i
360 854 9559
f
866 783 1742
WebSwitch Installation and Operation Manual
SETUP
2.3.4 Out1 and Out2 Setup Pages
These pages are used to set up the function of the two outputs. The Out1 page is
used to configure the output labeled Out1, and the Out2 page is used to configure
the output labeled Out2. Both pages look and operate the same.
1. Auto Reboot:
When this option is set to ‘ON’, WebSwitchTM will operate in Automatic Reboot
mode. In Automatic Reboot mode, WebSwitchTM is configured to periodically
confirm that another device (such as a server, computer, router, etc.) is working by
sending ping requests to the device. WebSwitchTM expects a response after each
ping. If a pre-set number of ping requests fail, it is assumed that the device is not
functioning properly. WebSwitchTM will attempt to restore the device to normal
operation by rebooting the device. In Automatic Reboot mode, users still have the
ability to manually reboot the device from a remote location over the network.
When this option is set to ‘OFF’, WebSwitchTM will operate in Normal mode. In
Normal mode, WebSwitchTM will only change the state of the outputs when com-
manded by a user.
The following parameters (2-3) are available only when Auto Reboot is set to OFF.
2. State at Powerup:
When this option is set to ON, Out 1 will immediately be powered when power is
applied to WebSwitchTM. When this option is set to OFF, Out 1 will not be pow-
ered when power is applied to WebSwitchTM. By default, this option is set to OFF.
3. Reboot Pulse Time:
This is the time (in seconds) that WebSwitchTM pulses the output ‘off’ and then
back ‘on’ to reboot the device connected to the outlet. WebSwitchTM executes the
reboot sequence when the user presses the reboot button . This time can be set from
1 second to 60000 seconds (1000 minutes). The factory default setting for this is 10
seconds.
WEBSITE:
Visit our web site for
product updates and
additional information.
