e-mail:
voice:
360.854.9559
fax:
360.854.9479
11
TS-6 Installation and Operation Manual
OPERATION
Auto Answer
If there is no call screener, the Auto-Answer DIP-3 switch setting can be used to
automatically answer calls and place them on hold. If DIP-4 is on (DIP-3 must be
off) the FLASH button / LED are changed to be used to toggle auto-answer on and
off. When the green FLASH LED is lit auto-answer will be on.
Conference Calls
To conference a line into the hybrid, press the CONF button followed by the line
button. Note: for conferencing to work properly it is important to properly connect
the telephone Tip and Ring on all six CO lines.
Dropping a Call
To drop a call press the Drop button followed by the line button of the call to be
dropped. If the call is on the Hybrid or connected to the phone output it will be
dropped and the LED’s will turn off. If DIP-1 is off and standard POT’s lines are
being used, the controller will monitor the lines for CPC (wink) loop control and will
also drop a line on a CPC signal or no loop current.
Flash Hook
A Flash Hook can be generated on any line that is either off-hook, connected to the
phone output or an active Hybrid line. To generate a 500ms Flash Hook signal press
the Flash button followed by the line button. This button can have an alternate use
if DIP-4 is on. Refer to “Auto-Answer”.
Record Control
Pressing the REC button, will cause the red record led to begin flashing. The REC
relay will not be engaged until a line button is pressed. When the record input goes
low the REC LED will change to solid red. The REC relay will stay on until the
STOP button is pressed. The STOP LED will flash and the REC relay will turn off
along with the REC LED.
Delay Button and DLY Relay
Pressing the DELAY button will toggle the DLY relay on and off. The green delay
LED will not light until contacts are closed on the delay input between pins 16 and 17.
OPT Button and OPT Relay
Pressing the OPT button will toggle the OPT relay on and off. The yellow opt LED
will not light until contacts are closed on the opt input between pins 22 and 23.
DTMF Keypad
The DTMF keypad can only be used on the Hybrid line connection (not the screen-
er tele- phone). When any button is pressed, the Switch Console will generate the
corresponding tone.
