1
2
3
4
5
6
7
8
9
10
11
12
14
AUTO mode indicator
COOLING mode indicator
DRY mode indicator
FAN mode indicator
HEATING mode indicator
TIMER OFF indicator
TIMER ON indicator
AUTO FAN SPEED indicator (flashing)
LOW FAN SPEED indicator
MIDDLE FAN SPEED indicator
HIGH FAN SPEED indicator
SLEEP indicator
Vertical
swing indicator
louvre
15
TURBO
indicator
13
17
HEALTH
indicator
ECO indicator
BATTERY indicator
Meaning
No.
Symbols
16
4
Signal receptor
(2)
Remove the battery cover plate from the rear of the remote
controller, by sliding it in the direction of the arrow.
Reinstall the battery cover by sliding it into place.
Install the batteries (+ and -) as shown on the Remote Controller.
Refer to picture 1:
Use 2 AAA (1.5V) batteries. Do not use rechargeable
batteries. Replace the old batteries with new ones of the
same type when the display is no longer legible.
Do not dispose batteries as unsorted municipal waste.
Collection of such waste separately for special treatment is
necessary.
1. Direct the remote controller toward the Air conditioner.
2. Check that there are no objects between the remote control
and the Signal receptor in the indoor unit.
3. Never leave the remote controller exposed to the rays of the sun.
4. Keep the remote controller at a distance of at least 1m from a
television or other electrical appliances.
Recommendations for locating and using the remote controller holder (if present)
The remote controller be kept in a wall-mounted holder.
(1)
P
U
S
H
Remote controller holder
5
Horizontal louvre indicator
18
Indicators On LCD
Replacement of Batteries
This remote controller can be configured to operate for both a
COOLING ONLY system, or a COOLING and HEATING system.
When you insert the batteries for the first time, or when
replacing the batteries, you can configure the remote controller
to suit your application. When the batteries are inserted, the
symbols and start flashing alternately. Pressing any
button when is displayed, sets the controller to COOLING
ONLY mode. Pressing any button when is displayed, sets the
controller to COOLING and HEATING mode.
If you do not make a selection while the symbols are flashing, the
symbols stop flashing after several seconds and the controller
adopts its default configuration of COOLING and HEATING mode.
Refer to picture 2: