8)
With the appliance on the wall offer the floating
shelf brackets to either sides of the appliance
lining up all 4x holes on the floating bracket with
the 4x holes on the sides of the firebox. Then
screw 8x firebox screws into the holes securing
the brackets to the appliance.
9)
Mark with a pencil through the hole in the end of
the bracket against the wall.
10)
Remove the appliance off of the wall.
11)
Drill a 8mm hole at least 50mm deep on either
side of the appliance where previously marked
12)
Tap the two wall anchors into the pre-drilled
holes with a hammer until they are flush with the
wall.
13)
Re-install the appliance back onto the wall
14)
Screw the wall screws through the rear of the
floating shelf brackets and into the wall plugs.
15)
Carefully, slide the bottom of the surround on to
the float shelf brackets
//
8.0 INSTALLATION
//
11
