●
The encoder is a precision instrument. Please handle it with care and use it carefully,
especially for the encoder shaft, please do not knock, hit or pull hard. Flexible connectors or
elastic supports should be used for the connection between the encoder and the machine, and
the rigid damage caused by the non-concentricity of the rigid connection should be avoided.
●
Although the encoder housing is waterproof (IP54), the protection level of the shaft is IP65.
Avoid installing the shaft upward or immersing in water, otherwise use a waterproof cover or
other measures.
●
Although the encoder itself will not lose the number of turns in the interference
environment, it will cause interference to the data in the transmission process, so when there is
a motor in the system or a strong electromagnetic interference environment, the encoder
power supply should use an isolated power supply and external extension It is best to use
double-shielded cables and other measures for the communication line.
●
The outer shell of the encoder shell and shielded cable should be well grounded to prevent
damage to the encoder circuit due to lightning strikes or high-voltage static electricity!
●
Except for the above zero-setting (yellow wire) allows grounding, any other signal wires of
the encoder are forbidden to be short-circuited with each other. After power-on, avoid
accidentally touching the signal wires, otherwise it may cause permanent damage to the
circuit!
Precautions for installation and use
Mechanical Size
4
The angle relationship
between the wire exit
direction and the 3 M3
mounting holes is random
D shape shaft
size ratio 5:1
Thread hole
depth 6mm
