Briteq BTX 5R BEAM, Operation Manual

Page: 8 / 100

ENGLISH OPERATION MANUAL
BRITEQ
®
6/95 BTX-BEAM 5R
commands from the controller it has to decode. In the next section you will learn how to set the DMX
addresses.
OPERATING INSTRUCTIONS

Do not switch the unit on and off in short time intervals as this reduces the lamp life.

Always unplug the unit when it is not used for a longer time or before replacing the bulb and or making the
service.

In the event of serious operating problems, stop using the fixture and contact your dealer immediately.

Important:
Never look directly into the light source! Don’t use the effect in the presence of persons
suffering from epilepsy.
Every time you turn on the unit, it will run built-in program to reset all motors to their home position, the
display will show the Briteq logo during the startup, you may hear some noises for about 20 seconds. It will
show warning sign if one of the checks fails during the reset and you can press the
MENU button to view the
error information. After that, the unit will be ready to receive DMX signal and the standard display will show
as below on the right.
Standard display explained:
Base 30°C Shows the temperature of the CPU in the base
001 Shows the DMX start address of the unit
Md.1 19Ch. Shows the currently selected channel mode (19ch mode on the display)
SETUP MENU - Main functions
Turn on the unit, press MENU button to enter into menu mode, press UP and DOWN buttons until the
required function is shown on the display. Select the function by pressing the ENTER button. Use UP and
DOWN buttons to choose the submenu, press the ENTER button to store/confirm and automatically return to
the last menu. Press MENU button or leave the unit unused for one minute to exit menu mode.
BATTERY BACKUP FUNCTION:
While the unit is disconnected from mains power, press UP button for one minute to enter into menu mode.
Press MENU button or let the unit unused during one minute to exit.