ENGLISH
USER MANUAL
BRITEQ
®
16/18
BT-CHROMA800
109-114
No function
115-120
PIXEL ORDER: A (standard 0°)
121-126
PIXEL ORDER: B (rotated over 180°)
127-132
No function
133-138
FAN AUTO: temperature controlled
139-144
FAN FULL: always on
145-150
No function
151-156
LINEAR dimmer curve
157-162
SQUARE dimmer curve
163-168
INVERSE SQUARE dimmer curve
169-174
S-CURVE dimmer curve
175-180
No function
199-204
LOAD FACTORY settings to SETUP MENU
205-255
No function
Remark: All functions in the control channel become active after 3 seconds.
RDM FUNCTIONS / REMOTE SETUP
RDM
means “
R
emote
D
evice
M
anagement
” (control the unit from a distance). This projector works with a brief
set of RDM-functions which means that it can setup a bi-directional communication with an RDM-compatible
DMX-controller. Some of these functions are briefly explained below, others will be added in the future.
•
The DMX-
controller sends out a “discovery command”, all RDM devices respond and send their unique
device ID.
•
The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:
•
Device name:
the actual name of the unit
•
Manufacturer:
Briteq
®
•
Category:
LED Dimmer
•
Firmware:
x.x.x.x
(firmware version of the projector)
•
DMX address:
xxx
(current DMX start address of the projector)
•
DMX footprint:
xx
(number of DMX-channels used by the projector)
•
Personality:
xx
(current personality or DMX-working mode used by the projectors)
•
The DMX-controller can send certain commands to each RDM device which allow remote setup of the units.
Thanks to this the projectors can be setup remotely.
The following functions can be managed remotely:
No more need to take a ladder and set all units one by one!
•
DMX START ADDRESS:
The start address can be set remotely from 001 to xxx.
•
PERSONALITY:
The DMX working mode (DMX-chart) can be set remotely.
These 2 functions make it possible to prepare a complete DMX-patch of all projectors on the DMX-controller
and send these data to all projectors at once. More functions will be added later.
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small
problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
