ENGLISH
USER MANUAL
BRITEQ
®
11/18
BT-CHROMA800
•
Install the wires firmly on the wire terminals of both modules, pay attention to the inscriptions for correct
wiring (power cable: “L”= brown wire * “N”= blue wire * “PE”= green/yellow wire)
•
Gently fix the connection wire to the module
•
Put the module in place and make sure that the rubber sealing is in place!
•
Firmly fix the module using the 4 screws.
•
Done!
De-activation of the d buttons for permanent FIXED installations
When the projector is installed in a fixed installation, it is important that the d touch buttons can be
turned off to prevent unwanted tampering or unintentional changes in settings due to rainfall on the touch
buttons. Attention: this function can only be turned on / off by DMX, please follow the instructions carefully:
De-activate d buttons:
•
Connect the projector to a DMX-console and make sure that ALL DMX-channels are set to 000.
•
Set channels 1+2+3 exactly to value 100 during at least 10 seconds
➔
Display and buttons are now turned off: the display will show
DISPLAY BLOCKED
Activate d buttons again:
•
Connect the projector to a DMX-console and make sure that ALL DMX-channels are set to 000.
•
Set channels 1+2+3 exactly to value 101 during at least 10 seconds
➔
Display and buttons are turned on again.
RENTAL / ENTERTAINMENT applications:
Standard equipped with 3pin XLR and lockable IP65-Power connector in/outputs for easy daisy-chaining.
Simply connect the projectors together, using good quality power and DMX cables. The best option is to use
our COMBI CABLES
→ check our website for details and different lengths.
Some general information on DMX:
•
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
“daisy chain” your DMX controller and all the connected units with a good quality balanced DMX-cable.
Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular.
•
Pin layout XLR-3pin: Pin1= GND ~ Pin2= Negative signal (-) ~ Pin3= Positive signal (+)
•
Pin layout XLR-5pin: Pin1= GND ~ Pin2= Negative signal (-) ~ Pin3= Positive signal (+) ~ Pins4+5 not used.
•
To prevent strange behavior of the light effects, due to interferences, you must use a 90Ω to 120Ω
terminator at the end of the chain. Never use Y-
splitter cables, this simply won’t work!
•
Make sure that all units are connected to the mains.
•
Each unit in the chain has its proper starting address so it knows which commands from the controller it
has to decode.
Settings for different uses:
STANDALONE WITH BUILT-IN PIXEL PROGRAM OR STATIC COLOR:
Use this function when you want an instant show on only 1 projector.
•
Connect the projector to the mains and turn it on.
•
Make the following settings in the setup menu:
•
NO DMX Mode:
set to Stand-alone
•
Show a static or changing color:
•
Working Mode:
select the option All Pixels ON
•
Color Effects:
select one of the colors, make a custom color or chose a color fade with the desired
speed.
•
Master Dimmer:
set the desired level for the light output
•
Show a Pixel Program with static or changing color:
•
Working Mode:
select one of the 22 internal Programs and adjust the speed and afterglow
parameters.
•
Color Effects:
select one of the colors, make a customs color or chose a color fade with the desired
speed.
•
Master Dimmer:
set the desired level for the light output
Note: No DMX-controller should be connected, otherwise the DMX-signal will have priority.
