ENGLISH
USER MANUAL
BRITEQ
®
10/18
BT-CHROMA800
HIDDEN menu
In the hidden menu you can reset the JOB Usage Time counter and adjust the white balance.
To access the hidden menu, simply press the ENTER-button for about 3 seconds.
Press the MENU-button to leave the hidden menu again.
Reset JOB Usage Time
Used to reset the timer that shows how long the unit was used on the last job.
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the display shows NO
•
Use ▼/▲ buttons to toggle between YES & NO.
•
Press the ENTER button to confirm.
LED Calibration
Used to set the white balance or to perfectly match the colors of several projectors or after changing
one of the LEDs of the projector.
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the display shows the selected color for LEDs 1 to 10
. (change with ▼/▲ buttons)
•
Press the ENTER button: the display shows the value (050-255) for the selected color / led.
•
Use ▼/▲ buttons to adapt the value between 050 and 255 and confirm with ENTER
•
Repeat these steps until you have the desired values. The settings will be automatically saved.
There’s also a shortcut to reset all calibration values back to 255:
•
Press the ▼/▲ buttons until the display shows: ALL LEDs = 255
•
Press the ENTER button: the display shows NO
•
Use ▼/▲ buttons to toggle between YES & NO.
•
Press the ENTER button to confirm.
Note: Use this function with caution as it overwrites all manual calibrations, no recovery possible.
ELECTRICAL INSTAL USE
Important: The electrical installation should be carried out by qualified personal only, according
to the regulations for electrical and mechanical safety in your country.
Electrical installation:
FIXED installations
Optional DMX and POWER in/output modules are available with stainless-steel cable glands for fixed
installation: can be purchased separately as
“
BT-CHROMA 800 - FIX install set
”
The set consists of 2 modules that can be easily installed instead of the standard connectors and 2 stainless-
steel hex socket bolts to secure the TILT-mechanism in the right position. (see points n° 1+ 2 in the description)
•
Remove the original connectors on both sides: gently remove the connection wire from the connector.
•
On the new modules: install cables with outer diameter which are adapted to the cable glands on the
modules (Power cable Ø = 10 mm * DMX cable Ø = 7 mm)
