Instructions for Installation & Use
Instructions for Installation & Use
34
35
Step 8.
Place baby into child seat. Ensure
baby is positioned with their back flat
against the back rest and their bottom
correctly positioned into the curved
seat base.
Step 9.
Check headrest and shoulder slot
position is level with shoulders but not
below.
The shoulder straps must be in the
slots which are nearest to the child's
shoulders but not lower than the
child's shoulders.
Always adjust the height of the
shoulder straps as the child grows.
Flat
back
rest
Curved seat base
Step 10.
Engage Buckle
ENSURE BUCKLE IS ALWAYS
CONNECTED DURING USE.
ENSURE ALL HARNESS STRAPS ARE
NOT TWISTED.
Step 11.
Remove all slack from the lap strap
area (including behind baby's bottom),
by pulling up on the shoulder straps.
Step 12.
Pull harness adjuster strap to tighten.
Ensure a firm but comfortable fit.
ENSURE ALL HARNESS SLACK IS
REMOVED.
Step 13.
Remove slack from the top tether
straps by pulling top tether adjuster
strap.
Tongue
Buckle
Shoulder
Strap
Lap
strap
Do not harness an infant wrapped in a blanket or swaddled as this increases the risk of ejection
and injury or death in a crash. The harness needs to fit firmly to the baby, any blanket or other
covering may be placed over the harness after it is adjusted. Arms and legs must be free and not
bound or wrapped together. The legs must sit on each side of the crotch strap.
12
11
10
8
9
SETUP
- HEADREST AND SHOULDER HARNESS
FOR
REARWARD FACING
SETUP
- HEADREST AND SHOULDER HARNESS
FOR
REARWARD FACING
Above Shoulder Level
Harness Straps
not below
green zone
Step 7.
Place buckle tongues into buckle
tongue holders.
Pull
WARNING: DO NOT LEAVE CHILDREN UNATTENDED
IN THE CAR.
7
