Installation: Rear-Facing
10
Rear-Facing
LATCH Installation
•
Figure A illustrates a typical rear-facing
LATCH installation.
1
Verify that your vehicle is equipped with
LATCH anchors .
•
If LATCH anchors are not installed, you
must use standard vehicle belt installation
methods.
2
If stored, remove LATCH connectors
from storage pouches under cover .
3
Press and hold the LATCH adjuster
release button, then pull to lengthen
LATCH harness to full length .
4
Fully recline the restraint and place it
sideways on the vehicle seat, with the
front facing toward you .
5
Verify that the LATCH harness is not
twisted, then attach the farthest connector
to LATCH anchor (
Fig. B
) .
•
A positive click confirms attachment.
•
If LATCH connectors will not attach with a
positive click, it may be necessary to switch
the LATCH connectors as shown on page 21.
6
Rotate seat into rear-facing position .
7
Verify that the LATCH harness is not
twisted, then attach the closest connector
to LATCH anchor (
Fig. C
) .
•
A positive click confirms attachment.
B
A
C
