Switching the LATCH Connectors
21
If the LATCH connector will not properly
connect to the LATCH bar in the vehicle,
the connectors must be switched from one
side to the other . This will ensure that the
connectors are correctly aligned .
1
Lift the front of the cover to access the
LATCH bar .
2
Slide one connector through both rear-
facing belt slots to the opposite side of
the restraint, so that both connectors
are on the same side of the restraint
(
Fig. D
) .
3
Loosen the loop on one connector (
Fig.
E
) .
4
Thread the other connector through
the loop created in step 3 to switch
positions (
Fig. F
) .
5
Slide the connector which is now
closest to the front of the restraint
through both rear-facing belt slots
to the opposite side of the restraint,
so that each connector is in proper
position on the LATCH bar .
6
Replace cover and continue with
installation procedure .
E
F
D
