Before you fit the dashboard to the motorcycle, it is easier to relocate the three indicator
lamps and ABS triangle into the pre drilled holes in the dashboard. Each indicator lamp
has a small raised area in the 12 o’clock position on the side of the lens. Use a knife or
small file to cut a ‘slot’ in the corresponding 12 o’clock position in each of the pre drilled
holes. This allows the lenses to sit down flush in the recessed pre drilled holes.
!
Use some silicone on the inside to hold these items in place, but DO NOT use a
strong glue as you may wish to remove them at a later date.
Fitting the Dashboard
Undo the two bolts holding the plastic backplate to the front of the top triple. (You will
not re use these bolts)
!
!
•
Pull the plastic back molding forward which allows you to slide the dashboard
flange in behind. Then slide in the Aluminum Black support plate (included in the
kit) in front of the dashboard flange.
•
Using the 30mm M6 Flange bolts provided, line up the holes and fasten the OEM
Bac Aluminum support plate + dashboard flange together to the top triple
and tighten.
•
This is a bit tricky so be careful not to cross thread the bolts into the top
triple clamp