!
!
•
Drill an ‘access’ hole’ through the backplate in the ‘hatched’ area as shown in the
photo. This hole is used later to access the low beam height adjuster screw.
Fitting the bottom bracket
The aluminum bottom bracket bolts to the bottom triple clamp in front of the front fender
as shown here :
•
Undo the two bolts holding the front fender to the bottom triple clamp ( you will
not re use these)
Fit the bracket into place using two 30 mm M6 button head bolts (provided) with a 10mm
spacer (provided) on each screw to position the bracket 10mm forward of the fender and
locate into the same fender mounting holes and tighten. You can use some non-permanent
thread lock on these bolts
!
!
Re fitting the indicator lamps and ABS triangle to the Dashboard
