4
5
Dial Control
Lever Control
JOYTHC85 W
JOYTHC95 W
JOYTHCK85 W
JOYTHCK95 W
JOYTHCKH85 W
JOYTHCKH95 W
1
2
3
4
5
6
7
8
9
joy care
joy care
joy care
Start / Stop
Product Features
2
1
1. Push Button Start/Stop Button
Press once to start the shower, press once again to stop
the shower.
If audible sounds are enabled a single short beep will
be heard when the button is pressed to turn the shower
on. A single long beep will be heard when the button is
pressed to turn the shower off.
Stand-By Mode
indicated by the light around the STOP/
START Button being on, denoting the shower is powered
and ready to start.
2. Temperature Control
Adjustable temperature control.
Temperature Control Device
The Temperature Control Device will activate if the
water inside the water heater gets too hot. The
Temperature Control Device will switch off the power to
the heating elements. Once the unit cools down to a safe
temperature the elements will come on again and reheat
the water within the water heater and the whole cycle will
repeat itself until the temperature is manually reduced.
Warm-Up Indication
The light around the START/STOP Button will flash as the
water heats up. Once the light stops flashing and stays
on, the shower has reached your selected temperature
and is ready to use.
If audible sounds are enabled two short beeps will be
heard once the shower is at the correct temperature.
Phased Shut Down & Indication
When the shower is turned off, water will continue to
flow and the light around the START/STOP Button will
flash for a short period while the heater cools down to
approximately 30’C, before automatically turning off.
This helps reduce limescale build-up.
If audible sounds are enabled short beeps will be heard
until the shower has turned off.
Maximum Temperature Setting (See page 17)
The shower enables the installer / user to set a
maximum temperature. Once the maximum set
temperature is achieved the temperature will not
increase even if the temperature control dial is increased.
3. Temperature Setting Indicator
The Digital Display shows a number between 1 (cooler)
and 9 (warmer) depending upon temperature (2) dial
setting, and maximum temperature setting.
Time Out Setting (See page 19)
The time out setting will ensure the shower turns off if
the user fails to manually turn the shower off. The Time
Out setting is pre set to 30 minutes but can be altered
prior to installation to either 5, 10 or 20 minutes. The
warning is three short beeps followed by a 2 second
pause, repeated for a minute, before the shower times
out.
3
Need help?
Give us a call on
0844 701 6273
and speak to one of our trained advisors.