4
•
Always switch off the power at
the consumer unit and isolate the
electrical supply before making any
electrical connections or if you have to
remove the cover of an installed unit.
•
The unit
must
be mounted on the
finished wall surface (usually tiled).
Under no circumstances must you
tile up to or seal around the unit as
this may prevent air circulating and
condensation escaping.
•
This shower unit
must
not
be
modified* in any way as this will
invalidate the guarantee.
* Except for top left pipe entry (see
page 12) where the product has
been designed to be modified by the
installer.
•
You
must not
fit a “water saving”
handset (whereby the flow of water
can be restricted or turned off) to the
shower, otherwise this can result in
scalding and/or unit failure.
•
Important:
To comply with BEAB
Care Mark (for use in Healthcare
and special needs environments) the
factory set maximum temperature
of 41ºC
must not
be altered. If the
maximum set temperature is altered
the shower will still continue to work;
however it will no longer comply with
the BEAB care mark.
General Information
•
Important:
Before using the
shower for the first time the
commissioning purge sequence
must
be carried out. Failure to perform this
operation may cause serious damage
to the shower and invalidate the
guarantee.
•
Warning:
This appliance can
be used by children aged from 8
years and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of appliance in a safe way and
understand the hazzards involved.
•
Children shall not play with the
appliance.
•
Cleaning and maintenance shall
not be made by children without
supervision.
Need help?
Give us a call on
0844 701 6273
and speak to one of our trained advisors.