================================================================================================
1019383-A
27
MAINTENANCE
DUST COVER & BEARING RETAINER
ASSEMBLY & LUBRICATION:
1.
Insert new Bearing Retainer (61) onto Brush Axle (56). The
Bearing Retainer (61) should fit flush on the Lower Pivot (43)
side plate with the Bearing Retainer (61) flange fitting inside the
hole in the Lower Pivot (43) side plate and hole in the Brush
Housing (45).
Note: Take care when assembling the new Bearing
Retainer (61) so that the Carriage Bolts (48) remain in Lower
Pivot (43) side plate.
2.
Assemble the 3 Lock Nuts (20) securing the Bearing Retainer
(61). Tighten all three Lock Nuts (20).
3.
Snap E-Ring (53) into place on the Brush Axle (56). Note: Be
sure E-Ring is fully engaged with groove on Brush Axle (56).
4.
Assemble the Dust Cover (42) to the Lower Pivot (43) side plate.
5.
Apply WD40, 3 in 1 oil or other similar light lubricant directly to
the inside of the Dowel Pin hole.
6.
Replace the Large Flat Washer (58) onto the Brush Axle (56)
until it touches the Bearing Retainer (61).
7.
Turn the Brush Axle (56) so that the Dowel Pin hole is horizontal
with the ground.
8. Apply WD40, 3 in 1 oil or other similar light lubricant to the Dowel
Pin (57) and insert into the Dowel Pin hole on the Brush Axle
(56).
Note: Center the Dowel Pin (57) so that an even amount is
showing on both sides of the Brush Axle (56).
9.
Insert the Drive Pinion (65) onto Brush Axle until it touches the
Large Flat Washer (58).
Note: Dowel Pin (57) will now be inside the Drive Pinion (65).
10.
Insert Flat Washer (59) over the Brush Axle (56) and into the
recess on the Drive Pinion (65).
11.
Assemble the Retaining Ring (62) onto the Brush Axle (56). Be
sure that the Retaining Ring (62) is fully engaged with the groove
on the Brush Axle (56).
12.
If removed, replace the Wheel Axle (44) from the inside of the
Brush Housing (45).
13.
Apply a light coating of general purpose axle oil/grease to the
Wheel Axle (44).
14.
While holding the Wheel Axle (44) on the inside of the Brush
Housing (45), insert the Wheel (46) onto the Wheel Axle (44).
Note: Wheel may have to be turned slightly to engage Wheel
gear with Drive Pinion gear.
15. Replace the Machine Bushing (50) and insert Cotter Pin (63)
into place on Wheel Axle (44).
Repeat for left side Wheel and Drive Gear service.
If Bearing Retainer (61) was removed,
continue with Step 1.
If Bearing Retainer (61)
was not removed, begin at Step 5.
QUALITY CONTINUES
WITH QUALITY SERVICE
If you have installation questions, are missing parts or need
replacement parts, don’t go back to the store!
Please find your product serial number and model number,
then contact our Customer Service department:
SERVICE
In North America and Canada call
Toll-Free:
877-728-8224
Chat online:
www.brinly.com
Email:
BRINLY.COM
Additional info and videos are
available on our website. Please
visit the URL above OR scan this
QR code.
ONLINE
LS2-42BH1-G
