Brinkmann 810-8503-SB, Owner'S Manual, Page: 12 / 63

LIGHTING THE SEAR BURNER:
1. Open lid before lighting sear burner.
2. Make sure control knob is in the “OFF” position.
3.
Push and turn the control knob to the “HIGH” position. Continue to push in
control knob while pressing electronic igniter for 3–5 seconds.
4. Once burner is lit, continue to push and hold control knob for
30 seconds.
5. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”,
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6. To turn off, turn control knob clockwise until it locks in “OFF” position.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE SEAR BURNER:
1. Open lid before lighting sear burner.
2. Make sure control knob is in the “OFF” position.
3. Strike and carefully place a match approximately 1/2” (1 to 2 cm) from the burner.
4. Push and turn the sear burner control knob to the “HIGH” position. Continue to push in control knob
while holding a match to burner. The burner should light within 5 seconds.
5. Once burner is lit, continue to push and hold control knob for 30 seconds.
6. If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
7. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the sear burner until the
problem is found and corrected.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
11