10
6. Repeat steps 3–5 for lighting each burner. Always use electronic igniter for lighting each burner. If
burner does not ignite using the push-button igniter, wait 5 minutes, see “Match Lighting the Main
Burners” section.
7. To turn off, turn each control knob clockwise until it locks in the “OFF” position. This does not turn off
the gas fl ow from the cylinder.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Turn the burner control knobs to “OFF”.
3. Place a paper match in the end of the matchlighter. Strike the match and
place through lighting hole in the left hand side of the grill to approximately
1/2” (1 to 2 cm) from the burner.
4. Turn on the FAR LEFT burner control knob to the “HIGH” position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to “OFF” and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the “HIGH”
position.
7. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the “OFF” position.
3.
Push and turn side burner control knob to the “HIGH” position.
4. Press the electronic igniter on the main control panel and hold for
3–5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”,
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6. To turn off, turn control knob clockwise until it locks in the “OFF” position.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting”
section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to “OFF”.
3. Strike and carefully place a match approximately 1/2” (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the “HIGH” position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting”
section of the owners manual.
Note: Observe fl ame height when lit: Flame should be a Blue/Yellow
color between 1”–2” when burner is on “HIGH”.
See section in manual on burner adjustment to adjust fl ame.
Lighting Hole
Matchlighter
Summary of Contents for 810-8503-SB
Page 31: ...Brinkmann 8503 Assembled 30 ...
Page 62: ...Brinkmann 8503 Armada 61 ...
