Brillion Land Commander III LCS11153-4, Operator'S Manual, Page: 55 / 76

1P423 Page 49 Rev0608
AMBER
LAMP
RED
LAMP
LH
FRONT
TANDEM
HAUL
ADAPTER
LIGHT MODULE
#8-32 Hardware
RED
LAMP
AMBER
LAMP
30' EXTENSION
HARNESS
LIGHT BAR
WARNING LAMP WIRING with REAR HITCH
All Harnesses should be firmly attached so that they don't droop or become torn loose by field debris.
Attach Light Module to Light Bar plate just above hydraulic hoses with two #8-32 x 3/4 Machine 1.
Screws, #8 Flat Washers, #8 Lock Washers and #8-32 Hex Nuts.
Wishbone Harness 3-Way Plug with single cord connects to each Amber Lamp and 3-Way 2.
Plug with double cord connects to each Red Lamp. 6-Way Plug of Wishbone Harness connects
to Light Module. Place Harness inside Light Bar Channel and attach permanently with provided
cable ties to Flats across channel opening.
Mount Tandem Haul Adapter to Rear Hitch with provided hardware. 3.
Connect both 10 Foot Extension Harnesses to Tandem Haul Adapter and run cords forward 4.
along the hydraulic hoses. When you reach the Light Module connect cord 4-Way Plug with 1
bullet. Connect the other cord to 30 Foot Extension Harness . Run harness forward along the
hydraulic hoses to its full length. Secure all harnesses to hoses or Rear Hitch where necessary
with provided cable ties. 7-Pin Plug connects to the tractor or its stored in Connector Holder
located on the Hose Holder Bracket. Allow enough harness length to reach tractor socket. Roll
or fold up excess if necessary.
Note: If adding rear hitch to older machine, disconnect 30 Foot Extension Harness from Light Module.
Connect the appropriate 10 Foot Extension Harness to Light Module and 30 Foot Extension Harness.
LCS3_AsmElectricalHitch
10' EXTENSION
HARNESS
WISHBONE
HARNESS
Assembly - Warning Lights
Assem
bly