Brillion Land Commander III LCS11153-4, Operator'S Manual, Page: 47 / 76

1P423 Rev0410 Page 41
FLAT WEAR
STRIP
ALLOY WEAR STRIP
HHCS,1/2-13 x 2-1/2
NUT,LOCK 1/2-13
FLAT POINT
STEEL POINT
10" WING
POINT
7" WING POINT
ROLL PIN,
5/16 x 2
ROLL PIN,
1/2 x 2
HHCS,7/8-9 x 4
HHCS,7/8-9 x 4-1/2
FRONT BRACKET
SHANK CLAMP
FRAME TUBE
SHANK ASSEMBLY
FRONT
NUT,LOCK 7/8-9
CADI V-CAST
POINT
DOUBLE ROLL PIN
CONFIGURATION
LCS3_AsmShank
SHANKS,WEAR STRIPS and POINTS
WARNING: Auto-Reset Shank is ALWAYS Under Load
Do not disassemble, spring is loaded and improper removal of bolts could result in
serious injury.
Shank is spring loaded and serious injury could result as shank resets.
Do not use hands or feet to dislodge any obstruction holding the shank in the
tripped position.
Remove four 7/8-9 Lock Nuts, 7/8-9 HHCS and Shank Clamp from Shank Assembly . 1.
Mount Shank Assembly to the frame at the proper locations based on the configuration of
machine you are assembling. See Machine Configurations . Secure shank assembly in
place by placing Shank Clamp on the front side of the frame tube and reinserting 7/8-9 x 4
HHCS in top set of holes, 7/8-9 x 4-1/2 HHCS in the bottom set of holes and 7/8-9 Lock
Nuts. Tighten 7/8-9 Lock Nuts in a crisscross pattern to 225 Ft-Lbs of torque .
Install Points with double Roll Pin configuration (supplied with point) which means the 2.
open end of the roll pins must be on opposite sides of each other.
Mount the appropriate Wear Strips with supplied hardware. 3.
Assembly - Shanks
Assem
bly