7K116
3.
Now, from the rear of the seeder (figure
27B), mount the L-shaped bracket to the
end plate with 5/16-18 NC x 1” capscrews
lock washers and nuts as shown.
Beneath this bracket mount the pickup with
two #8-32 x 1 1/4” machine screws, flat washers,
lockwashers, and nuts.
Extend its longer wire up
toward the side of the
seedbox to meet the wire
from the acre meter.
Figure 27B
MACHINE SCREW,
GROUND
WIRE
BRACKET
MAGNET
WHEEL
PICK-UP
REAR OF
SEEDER
1/8”
GAP
CAPSCREW,
5/16-18 NC x 1”
LOCKWASHER, 5/16”
NUT, 5/16”
#8 LOCKWASHER
NUT, #8-32
#8 FLAT WASHER
Attach its shorter wire to the ground on the
bracket. (Remove paint under the terminal to
assure a good electrical connection.)
4.
Press the magnet wheel firmly onto the shaft
as shown in figure 27B.
There should be
a gap of 1/8” between the pickup and
the magnet wheel.
5.
Plug the acre meter cable into the pick-up
box cable.
FRONT OF
SEEDER
REAR
Page 37
900rev601
