7K116
5.
Drive Shaft Clutch:
5a. Run In :
(This procedure is necessary
for all new clutches and any clutch which has
not been used for approximately 60 days.)
1. Mak sure tractor is off and PTO is
disengaged.
2. Disconnect the drivline from the
tractor.
3. If necessary, disconnect the driveline
from the overseeder.
4. Loosen the bolts on the outside
diameter of the clutch until all bolts
are just loose, then tighten all bolts
one half turn.
5. Attach the driveline to the seeder and
to the tractor (the seeder three point
linkages must also be attached to the
tractor).
6.
Stand Clear of the PTO shaft
, turn the
tractor on, and engage the PTO shaft.
Run for a few seconds, or until the
clutch visibly smokes, then disengage
the PTO.
7. Turn off the tractor, and disengage the
driveline from the tractor and from the
seeder, if necessary.
8. Tighten all the bolts on the outside
diameter of the clutch equally until the
compression plate is tight against the
housing.
9. Reconnect drive shaft to seeder.
5b. Adjustment:
The friction clutch does not require any
adjustment - the bolts are to be tight at all
times.
Loosen these bolts
on the outside
diameter.
CLUTCH
Figure 8
Page 14
900rev601
