TROUBLE SHOOTING:
CAUTION: Ensure fixture temperature is cool enough to touch. DO NOT clean or perform maintenance while fixture is
energized.
• Clean lens and fixture housing with non-abrasive cleaning solution.
• Do not open fixture to clean LED. Do not touch the LED.
• Do not spray liquid directly on to LED, LED driver or wiring.
WARNINGS:
CLEANING & MAINTENANCE:
• Check that line voltage at fixture is correct.
• Ensure that there is voltage at lamp fixture wires. If there is no voltage, then check all connections.
• Check that fixture is grounded properly.
If fixture does not light/start:
• Check switch to ensure that there are no defects.
• Check fuse/circuit breaker for trips, then check wiring connections.
Bright33™ warrants its light emitting diode (LED) fixtures, including the LED arrays and the LED drivers and integral control
devices to be free from defect in material and workmanship for a period of five (5) years from the date of purchase based
on three hours of average usage per day for seven days a week. The finish material is warranted for a period of one (1) year.
If a Light Fixture fails due to a defect covered by this warranty, Stream33 Products LLC will replace the product. To make a
warranty claim, retain the failed products and send with proof of purchase, register receipt, your name and address to the
following address within thirty (30) days of the failure.
FIXTURE LIMITED WARRANTY FOR RESIDENTIAL USE:
Stream33 Products LLC
350 Courtney Road
Sebring, Ohio 44672 USA
1
| ENGLISH
Turn power off before installation, inspection, or removal.
Use all necessary precautions while performing this
procedure.
Consult a qualified electrician to ensure correct branch
circuit conductor. Min 90ºC supply conductors.
Properly ground electrical enclosure. IT IS IMPERATIVE
THAT THE OUTLET BOX BE PROPERLY GROUNDED.
This Integrated LED Fixture™ has no lamp/bulb to replace.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS,
OTHERWISE SAFETY WILL BE COMPROMISED.
GENERAL:
All electrical connections must be in accordance with
local and National Electrical Code (N.E.C.) standards. If you are
unfamiliar with proper electrical wiring connections, contact and
obtain the services of a qualified electrician. Use UL or IEC approved
wire only for input/output connections.
Remove fixture and mounting components from the box, and make
sure that no parts are missing, by referencing the illustration in the
illustration instructions.
NOT DIMMING COMPATIBLE: This product is NOT compatible with
dimmers. Fixture performance could be compromised by wiring
fixture with dimmer. DO NOT USE WITH DIMMER(S)!
This product has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits provide reasonable protection against harmful interference in
a residential installation. However if this product is not installed and
used in accordance with the instructions, it may cause harmful
interference to radio communications
