Briggs & Stratton Twin Cylinder L-Head, Repair Manual

Page: 39 / 171

3
6
4. Remove carburetor from intake manifold, Fig. 10.
a.
Discard gaskets.
Fig. 10 – Remove Carburetor
Horizontal Crankshaft Models –
Pre-Twin II (Type Nos. Under 1100)
Carburetor and intake manifold must be removed as
an assembly, Fig. 11.
1.
Remove air cleaner assembly.
2. Remove fuel and vacuum lines from carburetor
fuel pump body.
3. Remove four mounting screws.
4. Loosen governor lever nut and bolt.
5. Remove intake manifold and carburetor with
governor lever and springs, Fig. 11.
Fig. 11 – Remove Intake Manifold & Carburetor
GOVERNOR
LEVER
BOLT & NUT
6. Remove carburetor mounting screws.
7. Disconnect throttle link from governor lever, Then
from carburetor, Fig. 12.
a.
Discard gaskets.
Fig. 12 – Disconnect Throttle Link
THROTTLE
LINK
Vertical Crankshaft – All Models
1. Remove air cleaner assembly.
2. Remove fuel and vacuum lines from carburetor
fuel pump body.
3. Disconnect backlash spring, if equipped.
4. Remove carburetor mounting screws.
5. Lift carburetor and spacer and disconnect throttle
link from carburetor.
a.
Discard gaskets.
Fig. 13 – Remove Carburetor
BACKLASH
SPRING
SPACER
THROTTLE
LINK