Assembly
Read entire operator’s manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, contact your local Briggs & Stratton service center.
If you need assistance, please have the model, revision, and
serial number from the identification label available.
Unpack Pressure Washer
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Adjustable Nozzle Extension
• Wheels (2)
• Parts Bag (which includes the following):
•
Safety Goggles
•
Operator’s Manual
•
Hose Fittings
•
Maintenance Kit
•
Accessory Storage Bag
•
Handle/Wheel Kit Fastening Hardware Kit (which
includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Axle Pins (2)
• Retaining Pins (2)
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Attach handle and wheel kit to main unit.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and pump.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
Attach Handle
1. Place handle (
A
) onto base (
B
). Make sure holes in
handle align with holes on base.
2. Insert carriage bolts (
C
) through holes from outside of
unit and attach a plastic knob (
D
) from inside of unit.
Tighten by hand.
Install Wheel Kit
The wheel kit is designed to greatly improve the portability of
your pressure washer.
NOTE:
Wheel kit is not intended for over-the-road use.
Install the wheel kit as follows:
1. Place the bottom of the pressure washer frame on a
flat, even surface.
2. Slide a wheel (
E
) over the axle pin (
F
).
NOTE:
Be sure to install wheel with raised hub inboard.
3. Slide axle pin through hole (
G
) in frame.
4. Retain wheel on axle pin with retaining pin (
H
).
5. Repeat step 2 through 4 to secure second wheel.
8
BRIGGSandSTRATTON.COM
D
A
B
C
C
G
F
H
E
Summary of Contents for F020377
Page 130: ...26 BRIGGSandSTRATTON COM Reservado ...
Page 131: ...27 Reservado ...
