Briggs & Stratton 6404, Installation And Operation Manual

Page: 35 / 180

35
Wireless Monitor Operation
1. Remove battery access cover ( C ) on back of
monitor and install 2 AA batteries. (Observe correct
battery polarity which is embossed in the bottom of
the battery compartment). Replace battery access
cover.
2. The wireless monitor does not have an on/off
switch. When batteries are installed correctly, the
GENERATOR READY green LED light will flash
once every 7 seconds indicating the status of the
generator.
NOTICE The wireless monitor was linked to the generator
at the factory. Communication will begin upon the installation
of the batteries and the generator being placed in AUTO
mode. You may need to press System Update one time.
Antenna Placement
The wireless monitor includes an antenna that was
installed at the factory.
Before shipping, the magnetic-backed antenna was moved
to the side of the generator to prevent damage ( A ).
Before starting the wireless monitor, mount the antenna on
the top of the unit ( B ).
A
B
DEALER NAME
DEALER PHONE
generator power
service needed
generator ready
system update
generator systems
1 low battery voltage
2 low fluid level
3 under/over voltage
4 engine does not start
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
5 low frequency
6 engine overspeed
7 high temperature
8 transfer switch
# of flashes service needed
C
Not for
Reproduction