Briggs & Stratton 10000 Watt, Operator'S Manual, Page: 19 / 68

19
Troubleshooting
Problem Cause Correction
Engine is running, but no AC output is
available.
1. Circuitbreakeropenordefective.
. Faultingenerator.
3. Poorwiringconnectionsor
defectivetransferswitch.
1. Resetorreplacecircuitbreaker.
. Contactlocalservicefacility.
3. Checkandrepair.
Engine runs good at no-load but “bogs
down” when loads are connected.
1. Shortcircuitinaconnectedload.
. Generatorisoverloaded.
3. Shortedgeneratorcircuit.
4. FuelPressureisincorrect.
5. Naturalgasfuelmixtureisincorrect.
6. Kinkedfuellinebetweenregulator
andengine.
1. Disconnectshortedelectricalload.
. See Essential Circuits .
3. Contactlocalservicefacility.
4. See Gaseous Fuel System inthe
InstallationManual.
5. See Gaseous Fuel System inthe
InstallationManual.
6. Removekinkinfuelline.Replaceif
necessary.
Engine will not start; or starts and runs
rough.
1. 15Ampfusemissingorblown.
. Fuelsupplyturnedoff,restrictedor
depleted.
3. Failedbattery.
4. Cloggedairfilter.
1. Install(new)15Ampfuse.See
System Control Panel .
. Openfuelvalve(s);checkpropane
tank.
3. Replacebattery.
4. Cleanorreplaceairfilter.
Engine shuts down during operation.
1. Fuelsupplyturnedoff,restrictedor
depleted.
. Faultindicatorblinking.
1. Checkfuelvalves,fillpropanetank.
. Countblinksandreferto Fault
Detection System .
Loss of power on essential circuits.
1. Generatorcircuitbreakerisopen.
. Transferswitchproblems.
1. Resetcircuitbreaker.
. Seethetransferswitchmanual.